Replaces
Replaces 2 Piece Fuel Injector Set ACDelco ACEEK00093
$426.95
Replaces Chevrolet GMC Front 10 Piece Steering & Suspension Kit TRQ PSA66466
$392.95
Replaces Chevrolet GMC Molded Plastic Door Panels w/Map Pockets Accu-Form 2023 L&R
$383.95
Replaces Chevrolet GMC Front 8 Piece Steering & Suspension Kit TRQ PSA66465
$380.95
Replaces Chevrolet GMC Molded Plastic Door Panels Accu-Form 2021 L& R
$359.95
Replaces Chevrolet GMC Front Upper & Lower 4 Piece Control Arm with Ball Joint Set TRQ PSA66464
$345.95
Replaces Chevrolet GMC Fuel Tank TRQ FTA07664
$314.74
Replaces Chevrolet GMC 2 Piece Fuel Injector Set ACDelco ACEEK00092
$270.95
Replaces Chevrolet GMC Molded Dash Pad Cover Accu-Form 206
$269.95
Replaces Chevrolet GMC Molded Dash Pad Cover Accu-Form 242
$261.95
Part Details
Specifications
Returns: Parts with electrical components cannot be returned once installed.
Attention California Customers:
WARNING: This product can expose you to chemicals including Acrylonitrile and Butyl benzyl phthalate (BBP)d, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you how to replace the turn signal stock, which activates the wipers on this 1989 Jeep Wrangler. You won't need any tools. You'll just need a new turn signal stock from 1AAuto.com.
We are showing you on this Jeep Wrangler, but this turn signal stock can fit in many different Jeep and GM vehicles. It's pretty simple. Just grab your old one, pull firmly, and it pulls from the switch stock.
You can see here the old one all worn out. The new one will actually let you see what motor the wipers are in. It's all the same. The new one from 1A Auto is going to install exactly the same.
It has a couple of keyways on it. You just need to put it in carefully, line it up, might have to turn it a few degrees. Push it in firm, and then you need to turn the wipers switch portion, and make sure it goes all the way in, and will activate the wipers. You can see it here installed. You can actually see what you're doing from the driver's seat.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
If your original lever has cruise control then no this is not listed to fit your Cutlass.
The high beam is controlled by pulling towards driver and away from driver for on/off of high beams. The actual high beam switch is inside steering column where this lever connects internally. So this will control high beam but if you are having a problem with high beam then it is most likely the internal part.
Yes, according to the information you provided, this part will fit your vehicle as long as you are without Cruise Control.
You need to find the controller for that it should be under the dash on the drivers side
This may mount, but the wires would be placed separately if your vehicle has delay wipers against non delay wipers.
