Returns: Parts with electrical components cannot be returned once installed.
Attention California Customers:
WARNING: This product can expose you to chemicals including Acrylonitrile and Butyl benzyl phthalate (BBP)d, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
How To Replace Turn Signal and Wiper Stalk 1987-95 Jeep Wrangler
Created on:
Tools used
No Tools Needed
1. Removing the Turn Signal/Wiper Stalk
Pull the old turn signal out firmly
2. Installing the Turn Signal/Wiper Stalk
Line up the signal's slots correctly
Push the stalk firmly into place
Turn the wiper switch portion to make sure the stalk is installed
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you how to replace the turn signal stock, which activates the wipers on this 1989 Jeep Wrangler. You won't need any tools. You'll just need a new turn signal stock from 1AAuto.com.
We are showing you on this Jeep Wrangler, but this turn signal stock can fit in many different Jeep and GM vehicles. It's pretty simple. Just grab your old one, pull firmly, and it pulls from the switch stock.
You can see here the old one all worn out. The new one will actually let you see what motor the wipers are in. It's all the same. The new one from 1A Auto is going to install exactly the same.
It has a couple of keyways on it. You just need to put it in carefully, line it up, might have to turn it a few degrees. Push it in firm, and then you need to turn the wipers switch portion, and make sure it goes all the way in, and will activate the wipers. You can see it here installed. You can actually see what you're doing from the driver's seat.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
49277
In Stock
Product Reviews
Loading reviews
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Chevrolet is a registered trademark of General Motors Company. 1A Auto is not affiliated with or sponsored by Chevrolet or General Motors Company.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.