Install Tip: You may be required to reset the vehicle computer after installation of this part.
Quality Tested - built to a strict level of product standards.
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
How to Replace Mass Air Flow Sensor 1992-2000 Chevy Tahoe
How to Replace Mass Air Flow Sensor 1996-2000 Chevy Tahoe
Created on:
Tools used
Socket Driver
8mm Socket
Tools used
Flat Blade Screwdriver
1. Removing the Air Flow Sensor
Disconnect the air flow sensor harness
Loosen the two hose clamps with a flat blade screwdriver
Pull the intake hose back, up, and off
Loosen the hose clamp
Pull the two ends of the hose free from the air flow sensor
2. Installing the Air Flow Sensor
Push the two ends of the hose onto the air flow sensor
Tighten the hose clamp with a flat blade screwdriver
Push the end of the hoses into place
Tighten the two hose clamps with a flat blade screwdriver
Connect the air flow sensor harness
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we are going to show you how to replace the mass airflow sensor on this 1996 Chevy Tahoe. The only items you are going to need for this is a mass airflow sensor from 1AAuto.com and a flat blade screwdriver.
Start off by prying off this tab and pulling back the harness. Now, using a flat blade screwdriver, loosen up this hose clamp and this hose clamp right here. We'll just fast-forward as Don does that. Now, pull the hose back and pull it up and off. Just loosen up this hose clamp and pull your mass airflow sensor free from the hose.
Pull the other end off and push that onto your new mass airflow sensor. Push the other end of the hose onto your mass airflow sensor. Just tighten up that clamp. Push the longer end of the hose in first and then push it back. Push the other end in. Make sure it is in place. Then tighten up those two hose clamps. Reconnect your harness and you are all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
ESA48436
In Stock
Product Reviews
Loading reviews
There are no reviews for this item.
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Chevrolet is a registered trademark of General Motors Company. 1A Auto is not affiliated with or sponsored by Chevrolet or General Motors Company.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.