★★★★★
September 23, 2021
Works and fits well
Replaces
Genuine original equipment part (OEM) that was factory installed on your vehicle by the manufacturer.
This part fits 2 vehicles spanning 2003-2007.
| Year | Make | Model | Description |
|---|---|---|---|
| 2005-2007 | Toyota | Tacoma | Toyota Tacoma Driver Side License Plate Light Lens Toyota OEM 81691-0C010 |
| 2003-2006 | Toyota | Tundra | Toyota Tundra Driver Side License Plate Light Lens Toyota OEM 81691-0C010 |
| Brand Label | Part Number |
|---|---|
| DIY Solutions | LHT08577 |
| Toyota | 81691-0C010 |
This item may be interchangeable with parts from other brands with the above part numbers. This information is provided only for reference and does not guarantee that the item you are purchasing is identical to parts with part numbers from the brands listed above. To confirm that this item fits your vehicle, use the above "Check Vehicle Fit" option.
1 Year Warranty
This item is backed by our 1-year warranty. In the event this item should fail during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
Hi everyone, Sue here at 1A Auto, and today were going to show you how to change the license plate bulbs on an ‘03 Tundra. You need any parts for your vehicle, click on the link below and head on over to 1aauto.com.
A Phillips screwdriver removes the plate light assembly. Take that screw right out and place it to the side, and then you just grab onto the assembly and pull forward. See the lip, and then you've got your connector in the back here. They don't give you much of a harness to push on it, but right there I'm going to just really twist the assembly and turn it off.
So to reinstall it, you take your light assembly, and you line up the notches. Seat it and turn. Lock it in, reverse procedure, bring that tab down, and seat it. Take your screwdriver with the Phillips screw on it, line it up, and lock it down.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Works and fits well
