Nissan Infiniti Oil Drain Plug Gasket Nissan OEM 11026-JA00A

Hi, I'm Mike from 1AAuto. We've been selling auto parts for over 30 years! We're dedicated to delivering quality auto parts, expert customer service, and fast and free shipping, all backed by our 100% satisfaction guarantee. So visit us at 1AAuto.com, your trusted source for quality auto parts.

In this video, we're going to be working with our 2009 Nissan Rogue. We're going to show you how to drain and fill your vehicle's oil, as well as how to remove and replace your engine oil filter.

If you like this video, please click Subscribe. We have a ton more information on this and many other vehicles. And if you need parts for your car, you can follow the link down in the description over to 1AAuto.com.

Here are the items you'll need for this procedure: 14mm socket, ratchet, drain pan, rags, oil filter wrench, oil, funnel

Remove your oil cap. Remove the 14mm oil pan drain plug with a socket and ratchet. Make sure you have a drain bucket under the pan before removing the plug, and place the plug somewhere clean and dry while you wait for your oil to drain. Reinstall the drain plug when the oil is finished draining, and tighten it back down with your 14mm socket and ratchet. Be sure to wipe up any excess oil spills.

And then your oil filter is actually located behind this little plastic cover. All of our clips are missing, so you may need to remove them, or you may just be able to pry it out of the way. You may need to use a strap wrench or filter wrench to help get this loose. And it does tend to leak onto the sub frame a little bit, so make sure you have a little extra room on your drain bucket. I'm just going to leave it loose and allow the oil to finish draining. Finish removing your oil filter, and always check to make sure that the old gasket is on there and not stuck to the engine.

If you double up on the gaskets it's not going to seal. Put some new oil on the tip of your finger and lubricate the gasket with it, then reinstall the filter onto its spindle. There's no need to use a tool when reinstalling these, just get them as tight as you can by hand. Wipe up any oil that made its way onto the sub frame.

Reinstall the pins to the inner wheel well if yours are still there. Fill the engine with 4-7/8 quarts of your favorite oil. Reinstall your oil cap, and run the vehicle for a few seconds to allow oil pressure to cycle through the motor. Shut it off and check your oil level. Correct as necessary.

Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.