How To Replace EVAPorative Emissions Purge Valve Nissan Titan
Created on: 2014-04-09
If the evaporative emissions purge valve (EVAP) on the 03-15 Nissan Titan needs to be replaced, watch this video and learn how to replace it yourself
-
step 1 :Removing the Evaporative Emissions (EVAP) Canister Purge Valve
- Remove the two 10mm bolts from the engine cover
- Lift the engine cover up and off
- Disconnect the EVAP canister purge valve wiring harness
- Loosen the purge valve hose clamps with pliers
- Remove the two 10mm bolts from the purge valve
- Pull off the purge valve
- Pry the hoses off the purge valve with a flat blade screwdriver
-
step 2 :Installing the EVAP Canister Purge Valve
- Put the hoses onto the purge valve
- Put the purge valve into place
- Insert the two 10mm bolts into the purge valve
- Connect the purge valve wiring harness
- Slide on the purge valve hose clamps with pliers
- Put the engine cover into place using the locating tabs
- Insert the two 10mm bolts into the engine cover
Tools needed
-
Flat Blade Screwdriver
10mm Socket
Ratchet
Needle nose pliers
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace EVAP canister purge valve on this 2004 Nissan Titan with a 5.6 liter V8 engine. The tools that you're going to need for this are a 10 millimeter socket and ratchet, a pair of pliers and a flat blade screwdriver.
You're going to need to remove your engine cover to start. Remove these two 10 millimeter bolts. We'll just fast forward as Don does that. Now pull up on either side of this engine cover. It just pulls off. Your EVAP canister purge valve is located right here. Just push the tab on this harness and pull it free. Then using a pair of pliers, push the teeth together on these hose clamps and slide them further down the hose. Then remove these two 10 millimeter bolts and we'll fast forward as Don removes those.
Now, using your flat blade screwdriver, just pry off these hoses. Take your new EVAP canister purge valve and just push the hoses into place. Then replace those two 10 millimeter bolts. We'll fast forward as Don replaces those and tightens them up. Reconnect the harness and then slide those hose clamps back up into place. Line up these two pegs with these two holes and push the engine cover back into place. Then just replace these two 10 millimeter bolts and tighten them up and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
How to Replace Vapor Canister Purge Solenoid Valve 1999-2003 Chevy Silverado
This video shows you how to install a new vapor canister purge solenoid on your 1999-2003 Chevy Silverado.
