Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to service your bulbs as well as replace the entire tail light assembly on this 2003 Chevy Monte Carlo. We show you on the passenger's side, but the driver's side is the same procedure. It's the same part and similar process on these Monte Carlos from 2000 to 2005. There are no tools required for this.
Behind your tail light in the trunk you'll see this thumb screw. Just remove it. Once you remove it, pull down the insulation and you'll see two more thumb screws on the back of the tail light. Just go ahead and remove these. Now, to service your bulbs, just pull the tail light out. For this bulb right here, you want to just twist it counterclockwise and pull it free. You can just pull the bulb out, push your new one in, and twist the socket back in clockwise. Make sure it lines up and is locked back in place.
For this bulb, twist it out counterclockwise, and pull the bulb out. Push your new one in, and twist the socket back in clockwise. This one is the same procedure. If you're looking to replace the entire assembly, just twist out each of your sockets and pull your harness from this bracket.
On the left is the old tail light; on the right is the new one from 1A Auto. You can see they're identical and they'll fit exactly the same. Remove the packing stickers from your new tail light. Take your sockets and just twist them back into your new tail light. Re-clip your harness to that bracket, and make sure none of the wires are in front of those studs. Line up the studs with the holes on the car and push it back into place. Now, we'll just fast forward as Mike replaces those two thumb screws, replaces the insulation and replaces that last thumb screw.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
