Replaces
Replaces 2013-16 Nissan Pathfinder Passenger Side Outer Tail Light TRQ LTA87514
$74.95
Replaces 2008-12 Jeep Liberty Tail Light Circuit Board Dorman OE Solutions 923-021
$39.95
Replaces 1995-00 Toyota Tacoma Driver & Passenger Side 2 Piece Performance Tail Light Set TRQ Performance LTA71062
$139.95
Replaces Chevrolet GMC Cadillac Driver & Passenger Side 2 Piece Tail Light Set DIY Solutions LHT07276
$67.95
Part Details
Product Features
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet. Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we are going to show you how to replace a tail lamp assembly on the 2006 Chevy Impala. It's the same operation for the left side and the right side as well as many of the model years from 2006 to 2012. Will also be showing you how to service the bulbs. You won't need any tools, just a new tail lamp assembly from 1AAuto.com. We're going to go ahead and do the right side, and we're going to locate a plastic wing nut right there. We're going to go ahead and unscrew that. Then go ahead and pull back the trunk carpeting, and you'll find to more elastic wing nuts right there and up on the top. We can go ahead and remove those. And I'm going to go ahead and fast-forward as I take those two off. Now you can remove the tail lamp assembly just pulling it backwards, and it'll expose the wiring harness as well as the sockets for the bulbs.
Servicing the bulbs is as simple as locating the bulb that is out. You're going to twist the socket, pull it out of the housing, and then pull the bulb straight out. All the bulbs back there in that housing are held in by sockets that need to be twisted, and then all of them directly just pull out and snap back in together. Replacing the tail lamp assembly, you're going to want to find the harness, pull up on the connector, and pull it out. Here you see the comparison of the old part and the new part, and they are absolutely identical ready to go right in. Remove the two plastic stud covers there if they are equipped with it. Those you are just going to throw way. It's for shipping and packaging purposes.
Then go ahead and find your harness, connect it to the body harness there, and then there is a locating pin on the tail lamp assembly that's going to go in the hole there in the right rear fender. Go ahead and push that in. On the inside, keep that carpet back and reinstall those plastic wing nuts, and I'll fast-forward as I tighten those back up. Go ahead and get your carpet in place. Get it over the stud there and behind that plastic trunk molding, and then reinstall your last of the three plastic wing nuts. And with the tail lamp assembly installed, you will notice the excellent quality of the tail lamp and how it fits into your vehicle.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
