Kit Includes: (1) Driver Side Power Window Motor (1) Passenger Side Power Window Motor
Quantity: 2 Piece
Specification
Side Location
Driver & Passenger Side
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
How To Replace Rear Power Window Motor 1993-99 Buick Lesabre
Created on:
Tools used
Socket Extensions
Flat Blade Screwdriver
10mm Wrench
10mm Socket
Ratchet
T25 Torx Driver
1. Removing the Door Panel
Pry up the switch panel
Disconnect the window switch wiring harness
Remove the Torx 25 screw from the door handle
Pry off the door handle bezel
Pry off the reflector on the edge of the door panel
Remove the 10mm bolts inside the edge of the door panel
Remove the 10mm bolts in the door pull
Pry out the door panel
Lift the door panel up and off
Disconnect the wiring harnesses
Carefully peel off the water shield
2. Removing the Window Motor
Disconnect the window motor wiring harness
Remove the three 10mm nuts from the window motor
Pull off the window motor
3. Installing the Window Motor
Put the window motor into place
Fasten the three 10mm nuts onto the window motor
Connect the window motor wiring harness
4. Inserting the Door Panel
Put the water shield into place
Connect the wiring harnesses
Lift the door panel into place
Push in the door panel clips
Insert the 10mm bolts in the door pull
Insert the 10mm bolts inside the edge of the door panel
Push on the reflector on the edge of the door panel
Push on the door handle bezel
Insert the Torx 25 screw from the door handle
Connect the window switch wiring harness
Push on the switch panel
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video we're going to show you how to replace a rear window lift motor in a '97 Buick LeSabre. It's going to be the same to do from the left door to the right rear door and it's going to work and apply to the '97-'99 model year.
Use a flat blade screwdriver and pry off the back, remove my switch by prying off the two plastic connectors, and be careful not to break them, or the two plastic tabs. Pulls this up and out of the way. The Torx 25 screw right behind the door handle. Get that out, and pull the plastic out. You may have to pull on the door handle a little bit to help get that plastic out from behind. Use a small pocket screwdriver to remove this reflector. Pressing in and down with the screwdriver helps get those clips that are on the top and bottom of that out. Now, we're going to take out four bolts one is right in here, one is straight in, and then you have two under where your switch pad was. I'm going to fast-forward this as I remove those four 10mm bolts. Now, I'm just going to get the rest of those clips off by prying between the door panel and the door itself. The clips I'm talking about are on the inner edge of the door panel. Just pop them, pull it out. Disconnect your harness by pulling the tab on the side. Go ahead and plug back in the connector there, place this one up through the back.
Use a flathead screwdriver to pry out this green clip, and then you can press in and disconnect the window motor. I'm using a 10 millimeter wrench to remove the three nuts that hold the window motor to the regulator. I'm going to speed it up as I remove those three nuts.
Re-installing the window motor, I'm going to fast-forward as I re-tighten those three nuts that hold the window motor to the window regulator. Go ahead and plug back in and then your green clip.
Just fast forward here as we put the water shield back on. Just make sure you pull the harnesses through and everything, get it back on there as best you can and we did miss filming taking that off earlier in the video, so obviously, if you have that, you'll pull it off and then put it back on before you put your door panel on. I'm going to go ahead and plug back in the connector there and fish this one up through the back.
Here, I'm just hanging the door panel on the sill of the door and then pressing in those yellow clips that I used my fingers on the inside of the door panel to pull apart and just making sure that the bolt holes are lined up. Then install a 10mm screw here. Here, I'm just installing the switch back into the switch plate, and pushing it down into the door panel. With the door handle cover, you're going to want to make sure that the notch where your lock and unlock fits up on the lock and unlock yellow rod there, and you have to pull handle out, play with that, and make sure that's centered. I'm reinstalling the Torx 25 screw.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
WMA07941
In Stock
Product Reviews
Loading reviews
5.00/ 5.05
5 reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
5
0
0
0
0
For window regulators
terry
February 12, 2017
Great price, shipped very quickly, and both works perfect.
Power window motors
Scott
April 27, 2017
I ordered these motors after testing the windows as per the 1AAuto video. The video was precise and really help me to diagnose and install the motors. Works like a charm. Thank you 1AAUTO.
SCOTT H
Power Window Motor Pair
Scott
July 29, 2019
These replacement motors looked exactly like the stock ones and fit perfectly. I watched the video and they became an easy install. Thanks 1A Auto!!
Windows Rollup Like New
Victor
August 7, 2019
I am very satisfy with the window motors that I purchased from 1A Auto. The window motors works perfectly in my Cadillac Deville, a matter of fact they have the power and works smoothly. They were a great find for me and the price was a steal.
Power window motor
Robert
May 12, 2020
They are a little loud. But, they work.
Customer Q&A
What is the differance between the two motors. I see one has a gear out and one in. Why?January 9, 2018
Michael D
10
Thanks for your question! These are the same motors only for opposite sides of the vehicle. They both have the same type of gear output. Thanks!!
January 9, 2018
Adam G
10
Only the out one is used the other one never see the light of day.Order them and put them,I did.Worked like a charm!!!
January 10, 2018
C S
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Buick is a registered trademark of General Motors Company. 1A Auto is not affiliated with or sponsored by Buick or General Motors Company.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.