Genuine original equipment part (OEM) that was factory installed on your vehicle by the manufacturer.
1 Year Warranty
This item is backed by our 1-year warranty. In the event this item should fail during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hey friends. It's Len here at 1AAuto. Today I want to show you something super neat. We have a tool for the Toyota antennas. It works for removing and also installing. You just slide this down your antenna so it comes through. This goes right onto the nut end of it. Then you can go ahead and turn it to the left or counterclockwise to remove your antenna or turn it all the way to the right until it bottoms out.
And then this tells you that you only want to tighten it to the point that it bottoms out and then an extra 45 degrees. Our reference for 45 degrees would be these little hatchings right here. That just shows you essentially if this was bottomed out right to here you would just bring it right about so that line lines up with the original line. So that would be approximately 45 degrees. You don't want to over tighten your antenna and snap the base. This tool is perfect for it. It doesn't give you too much leverage but just enough for when you're removing, you'll be able to get it off easy peasy. With that said, if you need this tool or any other tool you can always check us out at 1AAuto.com. Thanks.
Thanks for watching. Visit 1AAuto.com, your place for DIY auto repairs for great parts, great service, and more content.
Tools used
Hey friends. It's Len here at 1AAuto. Today I want to show you something super neat. We have a tool for the Toyota antennas. It works for removing and also installing. You just slide this down your antenna so it comes through. This goes right onto the nut end of it. Then you can go ahead and turn it to the left or counterclockwise to remove your antenna or turn it all the way to the right until it bottoms out.
And then this tells you that you only want to tighten it to the point that it bottoms out and then an extra 45 degrees. Our reference for 45 degrees would be these little hatchings right here. That just shows you essentially if this was bottomed out right to here you would just bring it right about so that line lines up with the original line. So that would be approximately 45 degrees. You don't want to over tighten your antenna and snap the base. This tool is perfect for it. It doesn't give you too much leverage but just enough for when you're removing, you'll be able to get it off easy peasy. With that said, if you need this tool or any other tool you can always check us out at 1AAuto.com. Thanks.
Thanks for watching. Visit 1AAuto.com, your place for DIY auto repairs for great parts, great service, and more content.
The wrench is to small and does NOT work at all. A waste of my money. Dont have the package to send back. Sorry for the bad rating but it doesnt work. Wish i could return. Yes i was the original antenna on the truck too.
This part is used to remove the Antenna and will work for a 2008 VW Rabbit
Yes, this part will fit your 2007 Toyota Tundra.
This is a universal tool for the Toyota vehicles.
No this will only work for Toyota antennas.
