Replaces
Part Details
Specifications
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.
Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii.
Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to service your taillight, both just changing the bulbs as well as replacing a complete assembly. At 1A Auto, we sell quality replacement assemblies if you back into something and break your taillight or something like that. You'll need a new taillight from 1aauto.com, as well as an 8mm wrench or socket and ratchet.
Open up your rear tailgate, and we'll show you on the passenger side but the driver side is exactly the same. There are two 8mm bolts that hold in the taillight. I'm going to use a 8mm socket, ratchet, and extension. A wrench would work as well. Remove those two bolts. With the bolts out, pull diagonally back and out at the same time. There are a couple pins that lock the light into place. Once you have the light free, if you're just looking to change the bulbs, all the sockets twist counterclockwise and come out. Then once you have them out, all the bulbs just pull straight out of the sockets and go back in. The bulbs have their part number printed on them so you can get replacements. If you need the unplug the harnesses from the sockets, there are just tabs on each socket. We press down on the tab and disconnect the socket from the harness.
Reinstall, either reconnect the harnesses or if your light doesn't come with the bulbs in place, put your old bulbs back in place. You just put them in and twist them in clockwise until they lock into place. You'll always hear a clicking sound when they connect. Then there are two pins that you look back in there, line them up into the body, and then give them a tap in. Set them and then put your two 8mm bolts back in and tighten them up nice in firm. Do not over tighten them.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
