Replaces
Frequently bought together
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet.
Hi, I'm Don, from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace a tail lamp assembly for a 2007 Pontiac G6. It's fundamentally the same for model years 2005 through 2010. You'll need a 10mm socket and socket wrench and a new tail lamp from 1A Auto.
On the inside edge of the trunk compartment, you're going to find a big plastic nut. You're going to go ahead and unscrew that and then pull the carpet down out of the way. Once that's down and out of the way, you're going to see two posts with 10mm nuts on them. Using the 10mm socket and socket wrench, you're going to remove the two nuts. I'll fast forward as I remove those.
Pull out the assembly. If you're just looking to service the bulbs, this is where you'll do it. They are screw type, so you unscrew them, and then, for this particular bulb, a small bulb, then just pull it in and pull it out and push it back in. Twist lock it again. Same goes for the other ones. You twist them. Pull them out. The bulbs just pull straight out, and they pop right back in and twist back in to lock them together. If you're looking to replace the assembly, pull up on the tab and pull out the connector.
We've got the old part, and we've got the new part from 1A Auto. It's direct-replacement fit. We're going to go ahead and install our connector. Find the locating pin on the end of the tail lamp and then the hole that corresponds with it in the body. Make sure that all lines up, and then the holes for your two 10mm studs line up, as well. Now, reinstall the two 10mm nuts that hold the tail lamp assembly in place. I'll fast forward as I tighten those up. Now, go ahead and push your carpet back into place and make sure it goes over the stud that your big plastic nut goes on. Go ahead and press the nut back in. Give it a good push.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the internet. Please feel free to call us toll-free 888-844-3393. We're the company that's here for you on the internet and in person.
