★★★★★
January 6, 2023
Quick delivery and perfect fit!! Thanks 1A
Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you removal and replacement of fog lights, as well as just changing the bulbs. It's a 2008 Dodge Ram. Same for 2002 to 2008, 1500, as well as the 2003 to 2009 2500 and 3500. You'll need new fog lights from 1AAuto.com, as well as a 10mm socket and ratchet.
You can access the back of your fog light pretty easily with the vehicle on the ground, but we're going to raise it up and just show you better underneath. If you're just looking to change the bulb, and for removal and installation, turn the bulb counterclockwise, pull it out, and you want to disconnect by pulling on the tab here and remove.
If you're just installing the bulb, reinstallation is just the reverse of that. Plug it back in. Put it in so it fits, and turn it to lock. You want to make sure you don't touch the glass part of the bulb when you're doing that, on the new bulb.
To remove a broken fog light, just remove these three screws. They're 10mm: here, here, and here. The light will come right out.
Reinstallation of the new light from 1AAuto.com, although we are just installing our old one, because it's in perfectly fine shape.
Put this side up in the first. Put it back in. Start the three bolts in. Tighten preliminarily. Check it from the front, and move it up and down if you like, and tighten up the bolts. Install the bulb as needed, and make sure it's plugged back into the harness. It's the same procedure for the driver's side.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
CS131-B000R
Quick delivery and perfect fit!! Thanks 1A
when scheduled and appeared to be exactly like the original. However, after installing it there was a small gap between the edge of the light and the plastic slot in the bumper. Not a lot and I could not adjust it to make it any tighter.
I could've gotten one cheaper elsewhere, but I trust this company the best. It looks great, fit right in, and is just a great replacement.
Finally found the part I need for my 2003 Dodge 2500. Great service and less than half of the cost from Chrysler corp. Received in excellent time . Would definitely recommend, and will use them first next time. Verg
Excellent quality product. One can never go wrong with 1a Auto parts and service!
Ordered the light - received prompt delivery. 1A site warned that bulb might not be included but was very pleased to see that the bulb was installed in housing. As an after thought a couple of days later I ordered the pair of hydraulic hood lifters. They arrived the same day as the light. Great service!
Easy installation and fits great. Looks even better than original part! Definitely recommend it!
Good price, looks great and was easy to install. Looks better than the other side, may need to replace other side to match.
I have replaced my fog light before and this one was of similar quality. Only 3 10mm bolts to deal with. I also noticed that while I purchased this for the front passenger side, that it is inter changeable with the drivers side. All you will need to do is switch around the set screw for adjusting the height of the light beam
Perfect fit, great price, fast fulfillment. Who could ask for more?
