Replaces
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the air conditioning and heater fan resistor. These vehicles have automatic temperature control. If your fan's not working or if it comes on at only high speeds or comes on at only low speeds, or doesn't quite take care of your needs as far as warming up or cooling down the car, usually that's a sign that your resistor has gone bad. It's a pretty easy procedure. You just need an 8mm socket with a ratchet and an extension and, as well, a flashlight will help.
Come on in here to your glove box, open it up. You'll want to remove anything that's inside of it. Then you just pull each side of it over. Then the glove box comes down. Then right back in here, this is your resistor. Press in and unplug one harness. Press in and unplug the other harness. Use an 8mm socket with a ratchet and extension. I'll just speed up as I remove the two bolts that hold the resistor in place. Pull it right out.
There's my original one, and a new one from 1AAuto. You can see it's going to connect all the same, with a slightly different look on the inside portion of it. It's going to go right in. Start one bolt. Start the other bolt. Again, I'll fast forward here. Start the bolts in; tighten them up with your 8mm socket and ratchet and extension. When you tighten them, you want to be careful not to over-tighten them, just get them in there, nice and firm. Plug it in. Bring your glove box up, push the side in. Push the other side in and your all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
